Both contain important safety information. Keep both for future reference. This supplement may be one of several for your bike. Be sure to obtain and read all of them.
|Published (Last):||18 March 2018|
|PDF File Size:||14.29 Mb|
|ePub File Size:||16.95 Mb|
|Price:||Free* [*Free Regsitration Required]|
As I've been riding the bike this season, I've noticed that the fork is behaving strangely. It doesn't seem to lockout fully and it. Find great deals on eBay for Cannondale Lefty in Forks. Keep both for future reference. In this supplement, particularly important information is presented in the following ways: Indicates a hazardous situation which, if not WARNING avoided, could result in death or serious injury.
A TIP provides helpful information. This manual meets EN standards , , and Intended Fork Use. Industry usage Conditions 1 - 5 are generalized and evolving. If your fork requires 1. Service, please take it to an Authorized Cannondale Dealer. A change in fork travel. An over-extended, elongated, or compressed boot. Use a 5 mm Allen key to loosen the brake caliper mounting bolts enought to remove the brake caliper from the mounting tabs.
Note brake alignment shims between brake bosses and the caliper. Replace correctly during reinstallation. Do not while tightening the hub bolt. Modify the fork in any way. Push black button again to return to open. This is not an adjustment when used with Lefty. This dial has been set at the factory. Make sure the bottom of the fork is clean. Remove the Schrader valve cap. Attach a bicycle suspension pump to the valve end. Before installation, make sure all part surfaces are clean. Apply a high-quality bicycle bearing grease to the surfaces indicated.
See shaded areas in illustration, next page. Make sure both upper and lower head tube bearings are fully seated in the headtube. Follow these steps carefully: 1. The adapter system must be installed by a professional bike mechanic. Here are some important points to remember about the kits: See the detail in the illustration. Ask your Cannondale Dealer to help you develop a complete fork maintenance program, one that suits where and how you ride.
Positioning a bumper incorrectly. Replace clamps as required. Always tighten securely, but do not over-tighten the clamps. Replacement cable clamps are available through a Cannondale Dealer. The air filter assembly stops the passage of dirt and water which would damage the internal fork components.
The cleaning procedure is the same for carbon or alloy outer tube forks. To clean and re-grease 1. Release all air pressure through Schrader valve in bottom of fork. Remove the front wheel. The techniques of resetting is the same for all forks, however, dis-engaging the damping cartridge differs. We provide the information in the supplement, however, we recommend that you always have this procedure performed by your Cannondale Dealer. Grease 28 Nm, In Lbs To reset 1.
It is available on the Policies page of our website at: Be sure to read the exclusions listed in the limited warranty. For example, damage from accidents and improper maintenance are not covered.
Cycling Sports Group Europe, B. Powered by Create your own unique website with customizable templates. Get Started.
Cannondale Tech Information